Grasshopper

algorithmic modeling for Rhino

Delaunay Mesh Connection Issue

Hi everyone, I am trying to create a faceted surface and I am dealing with a little bit of a roadblock.

I triangulated a surface and created points on each of the connections, then I created points from the centers of the same triangles and extruded them randomly.

So, when you connect the center point with 2 corner points, it should create a triangular surface. However, when I use Delaunay surface to do this, it connects to more points then it should and creates a weird surface. You can check the attached image for reference. The image on the left is when I "bake" my definition, and the image on the right is when I bake the points only, and manually connect them in Rhino. As you can tell, manually doing them would take a lot of time. Is it possible to solve this in grasshopper?

Del_Surface.gh

Views: 1110

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 27, 2017 at 11:14am

Try not to "Flatten" Delaunay mesh's input "P".

Permalink Reply by TM_Akman on August 27, 2017 at 11:18am

I had tried that before and it didn't work. I just tried again, and this is what I get;

Permalink Reply by Hyungsoo Kim on August 27, 2017 at 11:40am

Check attachment.

Attachments:
Permalink Reply by TM_Akman on August 27, 2017 at 11:46am

Thank you very much, I appreciate it. I can find other ways to have straight edges, or connect them manually, better than doing the whole thing :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service