Grasshopper

algorithmic modeling for Rhino

mesh from grid - can not fill the triangles in the edges

I an trying to create,place a panel - module to the grid gaps.

 I used the component wbWeave mesh from lines but there are gaps at the edges of the surface that I have set.

The is a solution, suggestion to this problem? 

Views: 665

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on July 24, 2017 at 7:27am

Have you ever tried "Diamond Panels" fr Lunchbox plug-in?

Permalink Reply by LINA on August 6, 2017 at 5:13am

Thank you very much for the reply.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service