Add WT or double angle to Cross Section Range Selector?

Replies to This Discussion

Permalink Reply by Karamba3D on July 17, 2017 at 1:54pm

Hi ooiooi0620,

at the moment (Karamba 1.2.2) angles as cross sections are not supported. Yet there is a work around: Use a suitable default cross section (which will serve for visual representation) and modify its mechanical properties via the 'Modify CroSecs'-component. Another option would be to write the values directly to a cross section table (see manual for details).

Karamba 1.2.2. assumes that the center of gravity and center of shear of a cross section coincide. This is however not the case for angles!

Best,

Clemens