Anchor Points Issue

Hi everyone, I'm following this tutorial and I've issues with my anchor points. It seems some of them is not 'associated' in GH eventhough I plugged into Kangaroo. I wonder why does it happen? what's my mistake?

Attached my GH:

Attachments:

Kangaroo membrane.gh, 25 KB
membrane.png, 452 KB

Replies to This Discussion

Permalink Reply by Mladen Babic on June 13, 2017 at 1:14am

Hello,

You can start simulation with 0 vertical movement, and move those up after start.

Permalink Reply by Gilang Arenza on June 13, 2017 at 8:40pm

Hi Mladen,

Thanks for the answer.
I didn't know if I need to start the simulation from 0

Cheers

Permalink Reply by Daniel Piker on June 13, 2017 at 4:22am

Hi Tan,

This is easier now using Kangaroo2 - it lets you set different inputs to identify which points to move, and where to move them to, to avoid this issue of having to move them back each time.

Attachments:

SimpleTensile.gh, 9 KB

Permalink Reply by Gilang Arenza on June 13, 2017 at 8:43pm

Hi Daniel,

Thanks for your reply!
Yes, know I'm migrating to kangaroo2 but it seems not all the components are not itnegrated into a new version. Do you think I need to keep the kangaroo 1? or can I combine those two version of force/goal components with a new solver?

Tan

Permalink Reply by Daniel Piker on June 14, 2017 at 4:36am

Hi Tan,

Which components from Kangaroo1 are you missing in Kangaroo2?

I think most of them now have an equivalent, except for a few of the more obscure and rarely used ones, but if something important is still missing I will try and add it.

You can install both versions side-by-side, but the force/goal components are not compatible.

RSS