Delaunay triangle incircle loft

I'm having an issue getting the circles created on the triangles coming out of a Delauney mesh component. I'd like to have the surfaces not twist but loft straight from the triangles to the circles. The circles seem to be going in opposing directions and their start points don't align with the start points on the triangles. When lofting in Rhino one can "adjust the seam" to get a loft to correct regardless of what the curve's direction or start point is. Any help would be appreciated.

Attachments:

Delaunay triangle incircle loft.jpg, 457 KB
Delaunay triangle incircles loft.gh, 13 KB

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 16, 2015 at 2:45pm

Hi. Andrew.

I'm not sure this is the best way of doing this, but can be a roundabout method.

Attachments:

Delaunaytriangleincirclesloft-re.gh, 14 KB

Permalink Reply by Andrew Vrana on February 16, 2015 at 2:59pm

Hyungsoo

That's did it! Thanks for your help.

-Andrew

Permalink Reply by Erick Vásquez on February 16, 2015 at 3:12pm

Hi Andrew after Delaunay just use FaceBoundaries to get the correct polyline.

Permalink Reply by Andrew Vrana on February 16, 2015 at 3:14pm

Erick,

I'll try that as well.

Thanks,

Andrew

Permalink Reply by Carina on May 20, 2017 at 3:27am

Hyungsoo Kim, can you please show me the third common of your code you posted for Andrew Vrana?
When I open you code, the third command is missing and this is exactly what I am looking for.
Thank you in advance.

Permalink Reply by Hyungsoo Kim on May 20, 2017 at 4:22am

That is "Mesh Explode" component fr "Mesh Edit" plug-in and you can do the same without it.

Attachments: