Grasshopper

algorithmic modeling for Rhino

Culling points with different Z values

Hi all,

I was wondering if there was a quick way to cull points that have the same X and Y values but different Z values, preferably keeping the point with the highest Z-value? I've thought of a way with "evaluate curve" but I feel that this will be quite heavy with a larger number of points. 

Thanks,

Laurens

Views: 2080

Attachments:

Replies to This Discussion

Permalink Reply by Joseph Oster on March 31, 2017 at 6:59am

This thread does exactly that:

Set Member Index Example (MIndex):
http://www.grasshopper3d.com/forum/topics/set-member-index-example-...

Permalink Reply by Laurens on March 31, 2017 at 7:31am

fantastic, thank you! Strange it didn't come up when I was searching

Permalink Reply by Joseph Oster on March 31, 2017 at 8:39am

Applied that very same code a few days ago on this forum, to a different set of points, same result - vertical lines:

http://www.grasshopper3d.com/forum/topics/tolerance-issue?commentId...

Permalink Reply by Laurens on March 31, 2017 at 10:52am

I've run into a small problem with trying to apply it for two separate lists, is there an obvious solution to this? I can't think why it would work for a single flattened list but not this. 

Attachments:
Permalink Reply by Hyungsoo Kim on March 31, 2017 at 11:01am

Hi.

Check this out. Best.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service