Loft problem

Replies to This Discussion

Permalink Reply by Ethan Gross on March 28, 2017 at 12:14am

Hi the seams of your curves were misaligned in pairs, so the the seam of curve 0 was on the side opposite that of curve 1 and so on, all the way up. I got the loft to work using 'normal' but apparently, you want the resulting surface to be developable and when I try that, its a mess - even in Rhino. Do you know for a fact that its possible?

Attachments:

• loft_problem regular-loft.gh, 25 KB

Permalink Reply by Hyungsoo Kim on March 28, 2017 at 2:47am

Hi. Findie

Try to fix your series of rotation angles from radian to degree.

Every 3 radian means more than 171 degree which means almost half turn of each section curves so that every section seams located alternately.

Permalink Reply by Findie on March 28, 2017 at 5:20am

OMG.

that was the mistake Hyungsoo Kim!!!!!

hope others will learn from it as well.

Great to have such a support.

Thank you once again.

Thanks goes as well to you, Ethan!!!!

Permalink Reply by Ethan Gross on March 28, 2017 at 8:20am

Good observation Hyungsoo. I just treated the symptom and not the disease.