Grasshopper

algorithmic modeling for Rhino

Simple problem: Orient orient's all ribs instead of one for each plane.

Hi, 

I believe I run in to a simple problem, but one iI can't seem to figure out.

I am trying to create ribs from a surface and then orient them for lasercutting.

But even while i created planes for each rib it projects every rib on every single plane...

somebody got a golden tip for me? 

Views: 257

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on March 25, 2017 at 9:50am

Try "Graft"-RMB over orient's B(Target Plane) input and choose Graft.

Permalink Reply by Mingus ten Cate on March 25, 2017 at 9:52am

Thank you so much!! I tried for 2 hours sigh

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service