Problem when baking walls created with wall extend component of VisualArq

I have a problem with the walls created with the wall extend component that I have used to extend a regular wall to a roof. The result of the baking to Rhino is only the lower part of the wall.

Replies to This Discussion

Permalink Reply by Francesc Salla on March 13, 2017 at 2:35am

Hi Orlando, the wall extend component only works if the geometry where the wall extends to is a referenced geometry in Rhino. So the workaround to cope with this limitation is:

1. Bake the geometry where the wall extends to.

2. Reference that geometry with a Geometry Param.

3. Connect that Geometry Param to the Wall Extend Component, G imput.

4. Now you can bake the wall

We will investigate how to improve this worflow.

Regards,

Permalink Reply by Orlando Carlos Olmos on March 13, 2017 at 7:01pm

Good to know, Thank you for your time.

Permalink Reply by Guillermo Ramírez on April 12, 2019 at 4:06am

Hi!

Is this issue already solved?

I am getting a "Solution Error: eInvalidInput" when inputting grasshopper generated geometry into the component.

Thanks!

Permalink Reply by Francesc Salla on April 12, 2019 at 4:46am

Hi Guillermo,

No changes about this. The Wall Extend component in GH only works with referenced objects in Rhino. But if you send me the definition or a screenshot of it I'll be able to figure out the reason of this error message.

RSS