interpolate between two surface shapes question

Replies to This Discussion

Permalink Reply by Jonah Hawk on March 1, 2017 at 11:05pm

Permalink Reply by Jonah Hawk on March 1, 2017 at 11:07pm

This is a clever tween tool you made. I like it. 
I simply grafted a range of values into the parameter of the evaluate Curve component. 

Permalink Reply by Findie on March 1, 2017 at 11:19pm

I found that definition in the forum  but had problems applying it to my definition see below

Attachments:

• interpolate_between_two shapes.gh, 21 KB

Permalink Reply by Jonah Hawk on March 1, 2017 at 11:17pm

fun! with BiArcs:

Permalink Reply by Findie on March 1, 2017 at 11:28pm

I applied your part to my definition and it kind of works.

however i would like to have the interpolated surfaces to run through the top and bottom points.

Would be great if you could check out my updated definition.

Attachments:

• interpolate_between_two shapes.gh, 24 KB

Permalink Reply by Hyungsoo Kim on March 1, 2017 at 11:48pm

You should match the U&V directions of the two surfaces first.

Attachments:

• interpolate_between_twoshapes_re.gh, 22 KB

Permalink Reply by Findie on March 2, 2017 at 3:35am

just got back.

Thank you Hyungsoo Kim for your great support!!!!! :)

Could i ask you one more question :how can u check if the UVs of the surfaces match or not?

Permalink Reply by Hyungsoo Kim on March 2, 2017 at 3:46am

Enable isocurve display with different U & V color of your surface display mode in rhino --> Bake your surface --> Check which one you should change U or V directions or flip

Permalink Reply by Findie on March 2, 2017 at 5:08am

Awesome.

found it in rhino options

Thank uuuuu

Permalink Reply by Michael Pryor on August 27, 2017 at 1:14am

Made this plug in that may be useful to you - http://www.grasshopper3d.com/group/milkbox/forum/topics/tweens-surf...