How to divide a triangular surface and acquire the similar results?

Hi guys,

I want to divide a triangular surface by vertical and horizontal dividing method, how can I do that? I don't obtain the desired result as all the vertical lines go to one point (fig. 1).

Also, I intend to distribute a pattern (fig. 2 | any shape) with similar distribution result, how point attractor can control where to not have holes? I mean make more solid areas where I need.

Thank you

Attachments:

01.jpg, 44 KB
Asteriskos-Design-Digital-Fabrication-Mary-O'Connor-Memorial-Transit-Shelter-Architekton-Tempe-Panel-Perforations-Shadow.jpg, 645 KB
Surface.3dm, 319 KB

Replies to This Discussion

Permalink Reply by Max Malein on February 24, 2017 at 11:55am

You can use a rectangular surface and trim it diagonally. This way you keep isocurves perpendicular to each other.

Use Cull Pattern to remove holes that are smaller then some threshold value.

Attachments:

01.PNG, 47 KB

Permalink Reply by Hardi Barznji on February 24, 2017 at 2:33pm

Thank you Max

Permalink Reply by Hardi Barznji on February 25, 2017 at 3:00am

Max my surface is twisted it is not straight as you can see in figure 1 when I try to divide the trimmed face it still gives me the full surface division as before the trimming.

When I trim the divided surface the result is only a few polygons next to the diagonal side (trimmed side) figure 2.

I have attached the .GH file if you look at it.

Thanks

Attachments: