Decimal Place in Panel component and Rhino Display Text

Hi,

Two questions as below:

1) I am trying to reduce the decimal place in the result of GH 'panel' component display (Please see the screen shot). Can someone please tell me how this can be achieved in Grasshopper.

2) I have used a 'line dimension' component to display dimension in Rhino viewport, however it displays everything in the 'panel' component to Rhino. Is there any way of telling GH to only display the number and the dimension unit from the panel component?

Please see attached screenshot to demonstrate the above two question. Hope someone can assist.

Thanks

Farjad

Attachments:

Example of problem 1.PNG, 84 KB

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 12, 2017 at 11:49am

Hi.

The following methods can be used as formatting masks for text input.

Attachments:

LineDimension.gh, 9 KB

Permalink Reply by Farjad Khan on February 12, 2017 at 12:23pm

Hi,

That's very helpful thanks! I have modified it a little bit, I have changed the panel input to '{0:0.000}mm' so it gives me the dimension in Rhino viewport.

Would you know how to change the decimal places in the panel output? (as per my question 1 in my initial post)

Thanks

Permalink Reply by Hyungsoo Kim on February 12, 2017 at 2:44pm

File-->Preferences-->Display-->D-Decimals

Permalink Reply by Farjad Khan on February 12, 2017 at 4:08pm

That doesn't seem to work. I even tried recomputing the whole GH document.

Regards

Farjad

Permalink Reply by Hyungsoo Kim on February 12, 2017 at 4:27pm

You want someting like this?