Grasshopper

algorithmic modeling for Rhino

Sweep 1 along multiple curves with one section is missing many rails

Hello everyone,

I need to sweep a section along many rails at one time, I don't know why but many rails are missing the sweep, as you can see in the jpg.

I attached the grasshopper file if anybody can help I appreciate.

Views: 3027

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on January 26, 2017 at 10:09am

Hi.

I'm not sure about the exact reason why the result of sweep1 is not always constant. Anyway in this case, there is a workaround using "Rail Revolution".

Attachments:
Permalink Reply by Hyungsoo Kim on January 26, 2017 at 10:31am

As you can see, if you place the initial plane at the starting point of the profile curve, you can see that the result is much more constant.

Attachments:
Permalink Reply by Hyungsoo Kim on January 26, 2017 at 12:59pm

You'll need to make some adjustments or tweaking when if sweep1 fails, but you can use my second suggested method posted above.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service