Make Same Block from different polygon sizes

Hi All ,

I am trying to achieve in grasshopper something that is done in a sketchup plugin called "s4u Components"

Basically It selects one face and makes it a component then morphs the block onto many other surfaces , the only rule is that it has to have the same number of sides

This would help a lot in the transfer between rhino and sketchup and the easiness of edit in both rhino and sketchup

Quick help would be very much appreciated since it would hugely facilitate a short time-lined project I am working on

Attachments:

11.jpg, 67 KB
22.jpg, 90 KB

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on January 2, 2017 at 9:35am

Are you looking for something like "Surface Morph" or "Box Morph" in GH?

Attachments:

Surface&BoxMorph.gh, 17 KB

Permalink Reply by Bogdan on January 6, 2017 at 11:39pm

I apologize for my stupid newbie question, but I can not understand how you created surfaces in GH, without Rhino tools, only nodes Geometry and Surface?! Once again, I'm sorry, perhaps I missed something in my training!

Attachments: