Diagrid curves offset in 3-D

Replies to This Discussion

Permalink Reply by WanyingWu on September 17, 2016 at 10:12pm

Here is the grasshopper file and rhino file. Both are needed because I referenced two point on Rhino.

Thank you!

Attachments:

• phenotype go!.3dm, 4.2 MB
• Pheno wthi plattezzo.gh, 13 KB

Permalink Reply by Hyungsoo Kim on September 18, 2016 at 9:24am

Hi.

If you want to make more advanced Pantheon like 3d thing, not just mapping diagrid offset curves onto a hemisphere, then, you'll need boolean difference operation.

Permalink Reply by WanyingWu on September 18, 2016 at 10:49am

That helps A LOT!!! Thanks!

Permalink Reply by WanyingWu on September 18, 2016 at 11:42am

This is exactly what I need but I can't figure out where these all connect too, and if I need to get rid of anything that is not helping.

Thank you!

Permalink Reply by Hyungsoo Kim on September 18, 2016 at 11:50am

If you don't mind to install some plug-ins, then I'll post mine.

Permalink Reply by WanyingWu on September 18, 2016 at 12:02pm

Do you mean the jackalope plug in? I have downloaded it!

Thank you!!

Permalink Reply by Hyungsoo Kim on September 18, 2016 at 12:06pm

You'll need "Lunchbox" too.

And you'll have to wait to open this until boolean operation will be finished.

Attachments:

• Rotunda.gh, 25 KB

Permalink Reply by WanyingWu on September 18, 2016 at 12:31pm

Thank you So much!! This was an immense help!