Grasshopper

algorithmic modeling for Rhino

List Items

Hi guys!

I am facing one problem here. I am sure you guys can help me.

                       20

                    19   18

                  17  16  15

               14  13  12  11

             10  9   8   7    6

           5    4     3   2  1  0  

I am triangulating this surface. I want to select just the red vertices. As you can note, I just need the inner vertices of this surface. I could do it mannually, but if I want to change the mesh density later, I will have to pick all of them manually again later.

Can someone help me? 

Tks

Views: 289

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on August 21, 2016 at 3:10am

Can you guarantee that the mesh vertices will always be so nicely ordered? Because if not you'll need to take a geometric approach. If however you need to generate the lists {1,2,3,4}{7,8,9}{12,13}{16} then there's lots of ways of doing that.

Permalink Reply by David Rutten on August 21, 2016 at 3:14am

Attachments:
Permalink Reply by Max Fabris on August 21, 2016 at 4:08am

tks a lot David! It worked.

I tried with different number divisions, and they worked properly. It seems that the order is always the same.

tks again!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service