voronoi evolver

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 14, 2016 at 9:06pm

I guess the cells of voronoi meshes were not properly joined and welded.

You should probably adjust the tolerance of "Mesh WeldVertices"component.

Permalink Reply by chih fan on August 14, 2016 at 9:15pm

ya, I did. But can't work out.

Permalink Reply by Hyungsoo Kim on August 14, 2016 at 9:18pm

And you've got a warning sign(red)fr second weaverbird component , I'm not sure why,

BTW, you are better off changing your voronoi curves to another combinations. 

Permalink Reply by chih fan on August 14, 2016 at 9:27pm

here is my file.

Attachments:

• voronoi frame.gh, 9 KB
• voronoi frame.3dm, 402 KB

Permalink Reply by Hyungsoo Kim on August 14, 2016 at 9:52pm

Your voronoi curves are inconsistent. Some cells have completely opposite directions and not planar.

Permalink Reply by Hyungsoo Kim on August 14, 2016 at 11:06pm

For example, some cells do not mach their edges each other. Very bad case.

So, don't blame the definition.

Permalink Reply by Hyungsoo Kim on August 14, 2016 at 11:42pm

In conclusion, your cells were not generated from voronoi component, i guess. You probably made arbitrary voronoi by hand with bunch of unnecessary lines.

Attachments:

• voronoiframe_re.gh, 23 KB

Permalink Reply by Hyungsoo Kim on August 15, 2016 at 9:26am

The only advice that I can give for such a man like you is

 "Don't mix with whatever ingredients(Ie, you don't understand) until you're ready to make a cake,"

  Your definition will gradually becoming "Frankenstein" and my part in this thing is over.

  Try to post another discussion regarding your attractor effect so that other forum guys can help.

Permalink Reply by chih fan on August 15, 2016 at 10:28am

Why the curves have graft, they can ascend obviously,the other not graft, ascend not obviously?

• ‹ Previous
• 1
• 2
• Next ›
• Page