algorithmic modeling for Rhino
Cull Pattern Problem
Hi Everybody,
I am trying to control a pattern as attached by an x-direction slider and an y-direction
slider to increase / decrease the number of elements.
It works fine for the y direction however not for the x-direction as shown in the attached graphic.
When the x direction slider is set to 4
in x direction five times 3 elements should be visible
which is not the case (see image 3) just five times 2 elements are appearing.
The same problem is happening when the x direction slider is set to 7
only 2 elements are shown in eleven rows.
Please have a look at the attached GH definition and the jpg which explains the problem.
I would be very glad if someone could help me to fix that problem.
Thank you for your support.
Views: 680
- Attachments:
-
-
cull_pattern_problem.jpg, 213 KB -
shatter_circle_into_two_segments_3.gh, 21 KB
-
Replies to This Discussion
-
Permalink Reply by peter fotiadis on
-
Like this?
- Attachments:
-
-
-
Added a LOL factor
- Attachments:
-
-
Permalink Reply by Hyungsoo Kim on
-
Hi.
Try this(Using "unflatten Tree") as well.
- Attachments:
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Pipe Pavilion
Added by Parametric House 0 Comments 0 Likes
-
Ring Pattern
Added by Parametric House 0 Comments 0 Likes
-
Point Attractor
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
