Grasshopper

algorithmic modeling for Rhino

Creating Surface from two Curves

Hello,

I have created an intersection of an extruded rectangle and a curved surface. This I want to offset and later extrude the surface between the intersection and its offset.

I first had to learn that it is impossible/difficult to create a surface from the original interesection, so I took the controllpoints and created a planar surface. Still, I am unable to loft the surface and its offset. 

Any ideas? Thanks in advance.

Views: 3831

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on July 28, 2016 at 7:29am

Try "Flatten" your Loft component's "C" input.

Permalink Reply by Shay Tavori on July 28, 2016 at 7:38am

If you offset the curve and duplicate the "create surface" group, you can get a loft which follows the curved surface rather than planar. And "flatten" C input of loft as Hyungsoo Kim suggested.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service