Karamba: analyzing error

hello i am a beginner in karamba .and i want to analyze displacement of some point on a diagrid structure in a tall building if it is exposed to wind load.these points are in floor levels of building.i have tried a point load component for each of these load cases but it shows that all of the displacements are zero or sometimes it shows the error of stiffness matrix

Attachments:

ax.PNG, 89 KB

Replies to This Discussion

Permalink Reply by Karamba3D on July 5, 2016 at 5:53am

I think you have to flatten instead of graft the Load-input of the assemble component.

Permalink Reply by sepide shoaee on July 5, 2016 at 8:25am

if i flatten it shows me one displacement for all of the structure.i want to have displacement for each load cas

Permalink Reply by sepide shoaee on July 5, 2016 at 6:40am

if i flatten it shows me one displacement for all of the structure.i want to have displacement for each load case

Permalink Reply by Karamba3D on July 5, 2016 at 1:10pm

Set the load-case of your loads via the 'LCase'-input-plug at the load-components. Then select the load-case to display via the ModelView-component (sub-menu at the bottom: 'Load-case Selection'). For further details please read the Karamba manual.

RSS