Grasshopper

algorithmic modeling for Rhino

Tensioned membrane geometry combination.

Hello,

i have a typical tensioned membrane Kangaroo script. Once I generate membrane I need to move rhino anchor points of the mesh with one button click. Actually I need to create some kind of command control center where i could click "Position 1" and every of anchor points will slowly change its XYZ to target position.

The idea is to achieve demostration look of possible membrane variations.

Thanks for any help!

Sincerely,

Dima, Vienna

Views: 519

Attachments:

Replies to This Discussion

Permalink Reply by Mohamed Naeim on June 26, 2016 at 9:26pm

I am sure this is not perfect, but is it close to what you want?

In this one, you choose a seeds for random locations each time , you reset the solver first

you can replace seed slider by alue list ( red group)

Attachments:
Permalink Reply by Mohamed Naeim on June 26, 2016 at 9:35pm

data internalized 

Attachments:
Permalink Reply by Dmytro Lutsak on June 27, 2016 at 3:31pm

hi Mohamed,

thanks for you help, but unfortunately your definition dosn't work properly. I understand what you did, but I only get this..I still need to move already defined points, and not create a new random points. For simplification it could be just Z axis or specific vector.

Permalink Reply by Mohamed Naeim on June 27, 2016 at 6:30pm

as i told you, its not perfect at the end 

i just made the part which let you change te corners , does that work

what do you need exactly

Permalink Reply by Mohamed Naeim on June 27, 2016 at 7:02pm

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service