Difficulties with creating a matrix

Hi everybody,

I have so much difficulties to solve a matrix problem.
i have curves in a set i want to loft. those curves are listed this way

e j o

d i n

c h m

b g l

a f k ...

and what i want is to loft abcde fghij klmno ... separetly, but impossible to separate my abcdefghijklmn list into multiple parts

Does someone have a direction to follow to succeed this operation?

Thanks a lot

Replies to This Discussion

Permalink Reply by Luis Fraguada on July 27, 2009 at 11:45am

Have you looked at the sublist component?

Permalink Reply by Yann on July 27, 2009 at 4:35pm

is there a way to set sublist with a generic way like "collect values 5 by 5" because i allready test sublist component but manually only.?

Thanks

Permalink Reply by Yann on July 27, 2009 at 5:11pm

Finally, i succeeded this way.

Attachments:

multi int.ghx, 108 KB

Permalink Reply by Elizabeth Tweedale on July 28, 2009 at 5:25am

If you want to change the number of inputs (say 8 instead of 5), using a VB script would be an easy way to go. I'll try and write a short one for you later just for future references because it seems like a common question from other people as well.

Elizabeth

Permalink Reply by Yann on July 30, 2009 at 2:57am

You are right, the concept is simple but i thought new trees tools were the solution or creating dynamic pattern for cull components. I effectivey didn't find anything about it before even if i did a large tour on exemples before. VB will be the next step for me...

thanks for your help

Permalink Reply by min tian on July 28, 2009 at 5:35am

would weave work in this case?
i'm presuming ejo, din, etc are all points on curves? so if you list those point data and write up the pattern in the panel?

RSS