Grasshopper

algorithmic modeling for Rhino

mismatched lists. how do I get draw only the desired circle from a list

Hi all,

here's an abstracted example of a problem I have. I'm trying to identify what's the shorted edge of each surface from a collection of multiple surfaces. Then I want to place a circle on each surface (centered/normal) with a value that's slightly smaller that that shortest edge distance.

Right now I get all the possible circles in all surfaces. I can see that my lists are not matched anymore after I extract the shortest edge of each surface. But I do not know how to re-link each to each surface. Makes sense? any ideas?

Thanks!

Gustavo

Views: 331

Attachments:

Replies to This Discussion

Permalink Reply by Ethan Gross on May 17, 2016 at 3:36pm

Gustavo, as far as I can see, all you need to do is graft the "C" input in your circle component.

Permalink Reply by gustavo fontana on May 17, 2016 at 3:49pm

hi Ethan, I'm not sure if this what you meant, but unflattening worked! thx

Permalink Reply by Ethan Gross on May 17, 2016 at 3:52pm

Either flatten the radii or graft the circles - same end result.

Permalink Reply by gustavo fontana on May 18, 2016 at 10:05pm
Got it. I tried a graft version too. Both work. Thanks!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service