Grasshopper

algorithmic modeling for Rhino

off set direction

hello there!

strange problem: I divided a surface, now I ma trying to offset the panels I obtained but I have two different directions: why?

the starting curve is continuos and closed, I think there is something wrong with the curve, but I don't understand wht and where.

any suggestions?

Views: 324

Attachments:

Replies to This Discussion

Permalink Reply by Dedackelzucht on January 13, 2011 at 12:50am
can you post the file ghx/3dm ?
Permalink Reply by June-Hao Hou on January 13, 2011 at 8:25am
Have you checked the direction of your divided curves?
Bake them to Rhino and use "dir" command.

It would help if you can post your GH definition and 3dm files.
Permalink Reply by paul piciorul on January 14, 2011 at 1:49am

yes, it depend by the curves direction, I designed new curves and now it works.

 

thank you.

Permalink Reply by kleerkoat on January 14, 2011 at 6:50am
i liked the behavior when it had a bug, when it didn't follow the direction, it followed the negative/positive offset value.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service