Lofting Offset Curves

Replies to This Discussion

Permalink Reply by Aditya Tognatta on March 17, 2016 at 3:31am

Hi mark!

do you only want to loft the last two curves? Anyway try this.

Permalink Reply by Mark Eden on March 17, 2016 at 3:34am

I want to loft all of them! I have managed to do it now. Ill upload the file. I have the loft, but now want to divide that entire surface (to make vertical lines) in the V direction, but it wont allow me to do it. any ideas?

Attachments:

• Dividing Surface in V direction.gh, 17 KB

Permalink Reply by Aditya Tognatta on March 17, 2016 at 3:38am

you didn't have to graft the curves before the merge.

Permalink Reply by Mark Eden on March 17, 2016 at 3:41am

Any ideas how I can divide that whole surface around those curves? Maybe my way isn't the best solution as now im stuck. thank you

Permalink Reply by Aditya Tognatta on March 17, 2016 at 3:45am

check your other post regarding the same.

Permalink Reply by mire on March 17, 2016 at 4:48am

Hi Mark, the short answer would be to flatten the input curves of the loft.

Assuming you want to loft all the curves I simplified your script to make it a bit easier

Attachments:

• OffsetLoft_.gh, 17 KB

Permalink Reply by Mark Eden on March 17, 2016 at 6:32am

Thanks alot