Frame Spacing Issue

Replies to This Discussion

Permalink Reply by Pieter Segeren on March 3, 2016 at 3:45am

Hi Bas, could you explain it a bit clearer, maybe provide some actual frame(s)?
Somehow I tend to think of the MassAddition partial results output, but I really don't get what the goal exactly is here.

Permalink Reply by Bas Goris on March 3, 2016 at 4:38am

Hi Pieter,

This is a table of frame spacing of a ship. 

From frame -20 till frame -10 a frame spacing of 10mm is used (in X direction),

from frame -10 till frame -5 a frame spacing of 25mm is used,

from frame -5 till frame -10 a frame spacing of 100mm is used,

etc.

Frame 0 is located on X=0 mm

Frame -5 will be on X=-500 mm

Frame -6 will be on X=(X of frame -5) -25 = -525 mm

Frame -11 wil be on X= ((X of frame -10) -10 =  ?? mm

etc.

Cheers,

Bas

Permalink Reply by Bas Goris on March 3, 2016 at 4:55am

Typo:

from frame -5 till frame +10 a frame spacing of 100mm is used,

etc.

Permalink Reply by Pieter Segeren on March 3, 2016 at 5:49am

Two pre-typo approaches attached. Adjust to fit your needs.

Attachments:

• Spacing_PSG.gh, 29 KB

Permalink Reply by Bas Goris on March 3, 2016 at 11:17am

Hi Pieter,

Dank je wel, thank you.

It seems to work......until I added other frames and frame spacing. Can you help again?

Bas

Attachments:

• Spacing_PSG_Wrong_Results.gh, 13 KB

Permalink Reply by Pieter Segeren on March 4, 2016 at 10:55am

You provided one too many framespace values: in between the four planes there are just three spacing values for use:
-5 ... 10 ... 50 ... 200

However, in case the frame at x=200 isn't the last frame of the whole series, but you want to continue beyond that, you'll need to add a new (last) value to the FramesFrom list (and maybe rename it to FramesFromTo). ;)

Permalink Reply by Bas Goris on March 10, 2016 at 12:30am

THANKS!