Grasshopper

algorithmic modeling for Rhino

one item noumber - two faces location?


hey, i want to creat few sub list for outside triangles of diagrid.

(separate for corners left right top and down ones)

everything goes fine i know how to describe them in relation to UV division but

For some item numbers Grassopper selects faces in deferent places. why? he should give them all addresses in same order. like in first 3 screen shots.

i am confused- were can i find explanation for this?

 

Views: 233

Attachments:

Replies to This Discussion

Permalink Reply by Giulio Piacentino on January 5, 2011 at 2:06am

I've added some comments to the definition. Notice that there was some duplicated data.

Use the Panel and the Param Viewer to check for it.

 

- Giulio

_____________

giulio@mcneel.com

McNeel Europe, Barcelona

Attachments:
Permalink Reply by Karol Wawrzyniak on January 5, 2011 at 12:35pm

hey,

thank you so much! i worked on it and it is ok now:)

but getting deeper in definition i got some new problems.

it is same definition but problems are very different so i created new post

http://www.grasshopper3d.com/forum/topics/newdiagonalsmulisurfacegr...

hope you can have a look

best

karol

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service