Solve Adjacencies error

hello everyone,

If anyone can tell why am I am getting gaps in my floor and roof - would highly appreciate it. I have attached the definition, it's a little hectic but I am going with it one level and one piece at a time.

Also checked: the missing floors are seen as ground floor and the missing roofs are seen as ceilings - so how do I properly change this?

Any suggestions are welcomed.

Attachments:

ground floor functions.gh, 1.9 MB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on February 29, 2016 at 6:25am

Haven't checked your model but from your comments.

1. The floor surfaces should show as ground floor in case the z value of all the points is 0.

2. Are you having other zones on top of these zones? A roof changes to ceiling if the boundary condition is another surface and not outdoors

Permalink Reply by Stefania Dinea on February 29, 2016 at 6:34am

Not at the moment - in a later stage I will have others on top. The thing is I create the zones from breps and I think I need to explode them and define each surface - which I was really looking forward to avoid.

As i said I am working on the ground floor before i go up.

On this subject - is there a tutorial or a file on how to make an atrium?

Permalink Reply by Mostapha Sadeghipour Roudsari on February 29, 2016 at 7:01am