Grasshopper

algorithmic modeling for Rhino

how to get a 2d drawing from a mesh

Hello, I'm trying to use make2d from mesh but obviously it doesn't work since its not a surface.  Is their another way of getting a 2d drawing from a mesh?

Views: 406

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 27, 2016 at 1:24am

Use "Extract wireframe" command and then "Make2D" should work.

Permalink Reply by Carlos Perez on February 27, 2016 at 1:32am

Thank you!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service