Development of the truncated cone

Replies to This Discussion

Permalink Reply by Joseph Oster on December 14, 2015 at 12:59pm

Is this a question?

Can you do ANYTHING in GH?  Like create the cone?  Maybe create the plane or surface cutting through it at a 45 degree angle?

This isn't complicated at all but if you can't at least create the cone in GH then you need to do more homework.

Permalink Reply by Wietse Elswijk on December 14, 2015 at 1:07pm

use UnrollSrf command in rhino after trimming a Cone, you can measure the distances, I guess... Not sure what the problem is though.

Permalink Reply by Alex on December 14, 2015 at 1:37pm

Delighted with your decision!
Thank you for your attention and support!

Permalink Reply by Joseph Oster on December 14, 2015 at 2:08pm

So this had nothing to do with Grasshopper?   ZZZ