Unroll/Flatten top surface of a spiral loop

Replies to This Discussion

Permalink Reply by David Rutten on September 29, 2015 at 5:36am

File?

Permalink Reply by B on September 29, 2015 at 6:20am

here is the rhino file

Permalink Reply by B on September 29, 2015 at 11:00am

rhino file for gh

Attachments:

• spiral - curve.3dm, 211 KB

Permalink Reply by B on September 29, 2015 at 5:45am

Hi David,

Im not sure where to begin.I will send of some pics over and the rhino file for you to see what i am trying to do.

Thanks,

B

Permalink Reply by B on September 29, 2015 at 6:00am

Hi David, here is a photo of the spiral loop surface. I am trying to flatten the gray layer. What is the best way to do this. I was able to flatten the purple layered surface in rhino. Thanks

Attachments:

• Spiral(1).png, 35 KB

Permalink Reply by B on September 29, 2015 at 10:31am

Here is the rhino file and GH file How would i go about unrolling all the surfaces to fabricate them

Permalink Reply by B on September 29, 2015 at 10:59am

GH file

Attachments:

• Spiral.gh, 19 KB