Problem perpendicular to curve

Hi guys!

I am tryin to rebuild this construction in rhino+grasshopper:

so far I have build the main carriers but I have problems with the panels in between. I want them to be perpendicular to the curves and their width should be from the curve till the offset of the curve (like in the picture).

hope anyone can understand and help :)

Attachments:

Untitled.3dm, 54 KB
unnamed.gh, 18 KB

Replies to This Discussion

Permalink Reply by Artur Mas on September 27, 2015 at 9:02am

Ok, i created a new script and managed to model the horizontal panels. Now my problem are the main carriers.

When creating an offset I get seperate curves which go to different directions (1.) and the first curve wont even get an offset curve (2.)

Attachments:

Untitled.3dm, 109 KB
unnamed.gh, 10 KB

Permalink Reply by Hyungsoo Kim on September 27, 2015 at 10:29am

Hi.

Not enough for fabrication, but It appeared to be close to your image and you can improve it even further.

Attachments:

ProblemPerpendicularToCurve_re.gh, 19 KB

Permalink Reply by Artur Mas on September 27, 2015 at 12:58pm

awesome! thank u once again Hyungsoo. I even managed to implement different carriers. There is only one problem left which i cannot solve: I want the horizontal panels to be dependent on the width of the carriers like in the picture.