Fillet a curve at a parameter

Replies to This Discussion

Permalink Reply by nikos tzar on September 27, 2015 at 8:03am

Hello Fong,

It sounds like you have the preview of both components turned on. Right-click on every component except [Fillet] and deselect "Preview".

If this is indeed the case then I suggest you take a look at some tutorials (https://vimeopro.com/rhino/grasshopper-getting-started-by-david-rutten) since this is a really basic question.

If this is not the case then please post your file(s).

Cheers, Nikos

Permalink Reply by Fong Weng Kong on September 27, 2015 at 6:46pm

Hi Nikos, Good day. I did deselect the preview except that for the fillet component. Please see file. Kindly refer to the one under "Channel"

Regards Fong

Permalink Reply by nikos tzar on September 28, 2015 at 4:32am

Hello Fong,

There is no file in your post

Best,

Nikos

Permalink Reply by Fong Weng Kong on September 28, 2015 at 5:10am

Sorry, missed it somehow.

Rgds Fong

Attachments:

• 150928_Fillet.gh, 6 KB

Permalink Reply by nikos tzar on September 28, 2015 at 5:39am

Ok, it'a not a preview problem. It's that you are trying to have a different value for each kink of the polyline and the fillet component does not work like this. What it does is to create as many curves as the values you input for radius:

Take a look at this topic. I believe it's what you are after.

best,

nikos

Permalink Reply by Fong Weng Kong on September 28, 2015 at 9:11am

OK and thanks