Grasshopper

algorithmic modeling for Rhino

Having trouble orienting bounding box to plane other than XY plane

I am fairly new to grasshopper, I am trying to distribute a custom surface (bulgy surface) multiple times across a larger sub-divided surface. The custom surface is intended to sit flat onto the sub-divided surface regardless of the orientation of the sub-surface (as shown in the picture).

I can only get it to work properly when the sub-surface is oriented to the XY plane because I cant figure out how to get the bounding box to orient with the sub-surface as it moves off of the XY plane.

Is there a way to re-orient the bounding box plane to a non-XY plane so the custom surface sits on the sub-divided surface properly?

Views: 831

Attachments:

Replies to This Discussion

Permalink Reply by Joseph Oster on August 4, 2015 at 11:26am

To orient a bounding box, see this recent thread:

Create face from multiple geometries
http://www.grasshopper3d.com/forum/topics/create-face-from-multiple...

This sounds like a job for Rhino "PanelingTools"?
http://wiki.mcneel.com/labs/panelingtools

Permalink Reply by Rauland Schaat on August 4, 2015 at 3:25pm

Joseph,

Thanks, that forum was very helpful

Permalink Reply by Hyungsoo Kim on August 4, 2015 at 12:30pm

Hi.

In this case , "Orient" is  simpler than "Box_Morph".

Attachments:
Permalink Reply by Rauland Schaat on August 4, 2015 at 3:25pm

Hyungsoo,

Thank you, I didn't realize how simple it could be.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service