Grasshopper

algorithmic modeling for Rhino

Moving Sunpath

I'm trying to move my Sunpath using sunPathCenPts so I can position it relative to other objects but when I connect a wire from Move and attempt to use Unit Z vector all I see is an X move up and down - the sunpath stays in place. Thanks.

Sunpath.JPG

Views: 548

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Abraham Yezioro on July 19, 2015 at 6:32am

Chris,

It won't be easier to input in the Sunpath component a CenterPoint?

I think this is what you want to do ...

-A.

Permalink Reply by Mostapha Sadeghipour Roudsari on July 19, 2015 at 6:34am

Hi Chris, Check the attached fie for an example. You need to connect the new point to sunPathCenPt input.

Attachments:
Permalink Reply by Mostapha Sadeghipour Roudsari on July 19, 2015 at 6:36am

PS: This is basically what Abraham

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service