Timer bug in Kangaroo 1

Kangaroo has been throwing this error today, on multiple different files:

An exception was thrown during a solution:

Component: Timer c_UUID: f1e9040a-01cf-46c2-b942-2352c029a065 c_POS: {X=846.5, Y=658.25}

Scheduled solution must have a delay of at least 0ms

including a slightly modified version of the stuttgartroof definition here:

http://www.grasshopper3d.com/forum/topics/how-to-create-chain-net-l...

It seems to be happening when I move the points too quickly.

Replies to This Discussion

Permalink Reply by Daniel Piker on July 8, 2015 at 4:53am

I don't recall seeing this error before.

Are you using the play button on the Kangaroo remote control, or the gh timer to run the simulation?

(or both? if so that might be the cause)

Permalink Reply by Christopher Edgemon on July 8, 2015 at 5:25am

As far as I know, I'm only using the timer.

I've only been using kangaroo for a few days, but haven't seen the remote control / don't know how to access it.

I've uploaded the relevant files. Steps for me to reproduce the bug:
1. toggle the Boolean off

2. move the center points around.

Sometimes it will pop up just after I have toggled the button, without me moving anything. Sometimes it will pop up after I've moved points, but when I'm just rotating the viewport.
Sometimes it will pop up immediately after I move points around.

Permalink Reply by Christopher Edgemon on July 8, 2015 at 5:31am

forgot files.

Attachments: