Multiple deforming points in a grid problem

Hello everyone,

I am relatively new to using grasshopper so i apologize for my inexperience,
I would like to know if there is anyway to modify the attached definiton in order to allow two points or more (preferably) to simultaneously deform the grid rather than just one point.

Grid%20Repelled%20by%20Point.gh

I tried setting another point as seen below but for some reason the grid appears to have collapsed.

Does anybody know how to solve this problem?

Thank you in advance :)

Replies to This Discussion

Permalink Reply by Riccardo Majewski on May 18, 2015 at 8:33am

Avoid using multiple wire links to a single input of a component.

Best is to use "Merge" component instead, to have control over the order of input's elements, trees management, and better "flow" of the definition.

Try this.

Attachments:

GridRepelledbyPoint.gh, 17 KB

Permalink Reply by Nhalaweh on May 18, 2015 at 12:23pm

Thank you Riccardo for helping me out much appreciated :)
Do you think there is a way to set a "deforming radius" for each point so that each point affects the grid in a different value? rather than the effect being uniform?

Thanks again :)

RSS