components gradient panelling

Hi,

i will like to ask if it is possible to make a gradient panelling with grasshopper. Until now, i only see component being populated over a surface in grasshopper. But is it possible to make a variation in terms of degrees of opening in this population?

Replies to This Discussion

Permalink Reply by jongsue kim on June 4, 2009 at 10:37pm

thank you so much :-)

Permalink Reply by Gabriel on June 26, 2009 at 3:20pm

can anyone explain how to use the graph mapper in conjunction with something to make irregular uv'f for a surface?

Permalink Reply by Dirk Anderson on June 26, 2009 at 5:55pm

It's outlined in the Grasshopper Primer. There's also another method to get non-linear distortion which I've posted here:
http://studio2008.ning.com/group/rhinodiscussiongroup/forum/topics/...

with a further explanation of how to clamp here:

Permalink Reply by Gabriel on June 26, 2009 at 6:15pm

thanks dirk - i knew i had seen them somewhere but I couldnt for the life of me remember where....