Grasshopper

algorithmic modeling for Rhino

Python basics. Working with point coordinates.

Hello, I am new to python/gh programing.I'm testing with a very small program, but it doesn't work as I expected. It processes each point three times, as you can see.

I suppose it must be some stupid mistake, but I have been searching for it and I've not been able to find a solution.
Could someone make me any suggestions?

Views: 3571

Replies to This Discussion

Permalink Reply by David Rutten on February 12, 2015 at 12:37pm

Is nudos a list input? I think the loop is iterating over the coordinates in each point, rather than over the list of points as a whole. That explains why everything is times 3 (once for x, y and z).

Permalink Reply by Enrique Vazquez on February 12, 2015 at 2:04pm

No, is a Item input.

Permalink Reply by djordje on February 12, 2015 at 3:03pm

That is what David was saying: you need to set the "nudos" to "List Access".
And change the:

    xpunto = nudos.X

to:

    xpunto = n.X

Permalink Reply by Enrique Vazquez on February 13, 2015 at 3:42am

I'm afraid that this change does not work

Permalink Reply by 筑梦NARUTO on February 13, 2015 at 2:38am

Hi Enrique，Check the attached files

Attachments:
Permalink Reply by Enrique Vazquez on February 13, 2015 at 3:43am

yes, thank you very much, this solves the problem

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service