Grasshopper

algorithmic modeling for Rhino

Modeling hinges in simple beam scenario

Hello,

I am trying to model a simple beam scenario where a beam clamped on two sides has a hinge in the middle. I modeled this after the Karamba Shear Hinge definition, as two beams with a free vertex each (clamped), and a common one (hinge).
However, I cannot seem to figure out the proper connectivity for the hinge. One beam ends up getting both it's edges as a hinge.

Can anybody share their experience with modeling hinges?

Attached is the file, adapted from the Karamba Shear Hinge definition, for reference

Thanks.

Yannis

Views: 608

Attachments:

Replies to This Discussion

Permalink Reply by Karamba3D on January 6, 2015 at 11:10pm

Hello Yannis,

I tried out your definition with Karamba 1.0.5, replaced the 'Hinge' and the the 'AssembleModel'-component with those from version 1.0.5 and now it works.

For backward compatibility Karamba contains some old versions of its components. The deprecated 'AssembleModel'-component used in your definition contains a bug as it seems. Sorry for the inconvenience.

Best,

Clemens

Attachments:
Permalink Reply by Yannis on January 12, 2015 at 4:02pm

Hi Clemens,

Thank you for the reply. I have tried the file and it works perfectly fine.

Best,

Yannis

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service