Grasshopper

algorithmic modeling for Rhino

why same code different error(unboundnameexception&typeerrorexception)

i want to join curves by using joincurves,but considdering the tolerance.If the distance between  end point of former curve and start point of later curves is smaller than the value of tolerance then join those two curves.

when i use the python script, same code running on different computers(but same software edition,both are rhino5 SR9&grosshopper 0.90076), different errors occur.

thanks for advice!

Views: 843

Replies to This Discussion

Permalink Reply by 筑梦NARUTO on December 21, 2014 at 6:07am

你需要输入curve等物体啊，，，不然就会出现这样的错误找不到曲线

Permalink Reply by studyrhino on December 21, 2014 at 6:12am

电池图上连上输入同样报错啊

Attachments:
Permalink Reply by 筑梦NARUTO on December 21, 2014 at 6:19am
上传文件吧。。。
Permalink Reply by studyrhino on December 21, 2014 at 6:33am

Attachments:
Permalink Reply by 筑梦NARUTO on December 21, 2014 at 6:47am

可以了。需要把C端改成list

Attachments:
Permalink Reply by studyrhino on December 21, 2014 at 7:02am
没注意到这个地方，官方的教程里也没提，十分感谢
Permalink Reply by 筑梦NARUTO on December 21, 2014 at 7:03am

官网并没有GHPYTHON的视频。只有rhinopython101啊。写代码时注意数据结构。数据类型就OK了。。。可以加入176301981这个群，一起学习

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service