Grasshopper

algorithmic modeling for Rhino

Need Help Split list to pick arc and lines issue

Hello Peeps,

Im trying to split a list of curves in 2 different list, but without succes.

I have found this old discution but it didnt help... http://www.grasshopper3d.com/forum/topics/extracting-a-specific-item

does someone have any solution?

Thanks in advance.

Views: 846

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on December 17, 2014 at 11:57pm
Your casing in the replace expression is wrong, "like" does not start with upper case.

Probably the easiest expression would be
If(Contains(x, "Arc"), 0, 1)
Permalink Reply by Homer Garcia Santana on December 18, 2014 at 2:42am

David,

Your first remark did the job. Thanks.

Permalink Reply by Kuber Patel on May 22, 2015 at 3:52pm

That command was definitely convenient. Thanks.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service