Grasshopper

algorithmic modeling for Rhino

Unequal rectangle offcet

Dear All,

I need to make unequal offset for a rectangle as following:

  1. deconstruct rectangle into lines.
  2. offset each one separately.
  3. compin new lines into new rectangle.

thanks in advance.

Views: 845

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on December 12, 2014 at 2:51am

Two solutions in the attached file. One using pure GH components stored in a cluster, the other using a VB component.

Attachments:
Permalink Reply by M.Elsayed on December 12, 2014 at 5:17am

Thanks David,

you are the star of this forum.

Permalink Reply by Philip Spore on June 27, 2016 at 3:08am

how do you find the center line of the rectangle? then create a vertical line?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service