Grasshopper

algorithmic modeling for Rhino

Daylight analysis Mesh results to Isoline

hallo, 

Is there a way to transform/ interpolate the resulted meshes of any daylight results into isoline curves? 

Attached is a basic example for daylightfactor, but i couldn't trasnform the mesh into isolines.

Thank you,

J.

Views: 374

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on December 5, 2014 at 7:28pm

Hi Nass,

The short answer is yes. Check this discussion for a similar question: http://www.grasshopper3d.com/group/ladybug/forum/topics/3d-result-v...

Mostapha

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service