Where is the weavebird clean up mesh component?

Replies to This Discussion

Permalink Reply by Giulio Piacentino on November 20, 2014 at 11:23am

Oh I know about this. I never got around to finishing that tool and releasing it.

If you bake the mesh and use Rhino's _AlignMeshVertices command, it should be enough.
I hope this helps,

Giulio
--
Giulio Piacentino
for Robert McNeel & Associates
giulio@mcneel.com

Permalink Reply by Sam on April 22, 2015 at 5:34am

I've got a similar problem. I wan't to use the wb_Offest component, but the it tells me that two consecutive edges have the same value and the topology is invalid and I need to use wb mesh cleaner.

Is there another way to solve the problem? Thanks!

best, Samy

Permalink Reply by Giulio Piacentino on April 23, 2015 at 1:13am

Try using Rhino's _AlignMeshVertices above (pretty sure it will work) or [uto]'s WeldMesh component with some tolerance.

Giulio
--
Giulio Piacentino
for Robert McNeel & Associates
giulio@mcneel.com

Permalink Reply by Claudio Campanile on December 8, 2016 at 4:01am

Hi Giulio

Just wondering if there is a way to call the function through rhinoscriptsyntax. It doesn't seem to be there in this library. So, I tried to look for it in Rhino.Geometry.Mesh - but still not there. Just wondering if you have any suggestions.

Thank you

Claudio

Permalink Reply by Giulio Piacentino on December 13, 2016 at 10:58am

In Rhino WIP you can now use

mesh.Vertices.Align(tolerance)

info is on the WIP page.

Thanks

Giulio
--
Giulio Piacentino
for Robert McNeel & Associates
giulio@mcneel.com

Permalink Reply by Simone Forconi on January 22, 2019 at 8:40am

Hi Giulio.

I have the same problem with my definition. I tried with everyone up, but nothing.

What i can do?

attached file and image
Many Thanks

Simone


Smooth%20mesh_01.ghsmooth%20mesh_01.3dm

Permalink Reply by Giulio Piacentino on January 22, 2019 at 8:55am

This is probably due to some collapsed faces. A possible way to fix it might be to bake the mesh and analyze what problems the _MeshRepair panel encounters.

Thanks,

Giulio

--
Giulio Piacentino
for Robert McNeel & Associates
giulio@mcneel.com