Surface Split Issue

Replies to This Discussion

Permalink Reply by ng5 Alex on November 13, 2014 at 2:48am

Hello

this could be one way

you need to data match the surfaces with the curves. this solution is for this case only. if you want a more general solution, then one could be to find the z position of the curves and sort them in lists accordingly and then find the closest surface to trim. it can become complex if the surfaces and curves are just in a list.

cheers

alex

*or find the intersection events before splitting the surfaces like Raul suggests (nice solution)

Permalink Reply by Raul Matagringo on November 13, 2014 at 2:49am

hi there,

for this setup:

i have this solution:

Dont forget to graft the "Crv" component.

oh, this was intersection...

But for the same setup it works for me:

Cheers,

R

Permalink Reply by Danny Boyes on November 13, 2014 at 3:00am

Here is a method for a set of random ordered surfaces intersecting some random ordered curves

Attachments:

• SplitSurfaceSorter.gh, 25 KB

Permalink Reply by dim gimi on November 13, 2014 at 4:42am

Thanks everyone and especially Danny. That did the trick. 

Attachments:

• HULL.jpg, 378 KB