Grasshopper

algorithmic modeling for Rhino

SDiff function no longer working

I need to cut holes from various strips using the solid difference tool. The Grasshopper string which was previously working has suddenly failed (1. Boolean Difference set is empty) after installing the plug-in RhinoNest. I am wondering if this is an issue of tolerance? (Model units : mm, absolute tolerance 0.01 units) or is there a problem in the code?

Any suggestions?

Views: 535

Attachments:

Replies to This Discussion

Permalink Reply by MARIO VERGARA on September 29, 2014 at 10:00am

i dont think is rhinonest

i have it installed, and your definitions is working ok

i have the same tolerance that you described

im working with version 09.0075

Permalink Reply by Patrick Bourgeois on September 30, 2014 at 4:38am

Thanks for your quick response - it was a big with the version of Grasshopper I was working on 09.0075 works again!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service