curve affecting extrusion height

Replies to This Discussion

Permalink Reply by nikos tzar on June 16, 2014 at 5:05am

I think you need to connect the distance output to the B input (divisor) of the A/B component (division). For start you could just switch places between A and B and take it from there.

Permalink Reply by Romero Barro on June 16, 2014 at 8:08am

so simple...;-)

thanks!

Permalink Reply by ng5 Alex on June 16, 2014 at 8:28am

Hello there

another approach would be with the remap values component

with this method you can also have control to the min max extrusion height (since you are remapping the distances, which could be too small or too large in the first place) and also reversing the ''effect'' by setting the start of the target domain higher than the end of it and vice versa.

Permalink Reply by nikos tzar on June 16, 2014 at 10:16am

much more elegant :)

Permalink Reply by Michael Pryor on June 16, 2014 at 11:12am

and to get exact opposite values

Permalink Reply by ng5 Alex on June 16, 2014 at 11:18am

oops missed the exact part in description

Permalink Reply by Romero Barro on June 16, 2014 at 1:13pm

very cool.

thanks!