Grasshopper

algorithmic modeling for Rhino

Insert/Orient AutoCAD Block to Point

I am currently trying to insert an AutoCAD block into rhino using grasshopper. I am creating a curtain wall unit and need specific mullion and transom profiles to be imported, oriented and located at specific points already determined by grasshopper. Also have been attempting to do this through VB Script, getting close, but thinking there may be an easier way.

Please advise. Thanks.

Views: 777

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Arend on May 11, 2014 at 7:44am

Sounds great! Congratulations, perhaps it's a good idea to share what you did?

Permalink Reply by Justin on May 12, 2014 at 8:20am

Still working out a few kinks, I'll definitely share once its complete and look forward to any/all input you can offer.

Permalink Reply by Arend on May 13, 2014 at 2:54am

You ask feedback on what you have, without submitting what you have, how do you figure that will happen?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service