Trim curves that are outside a form in Grasshopper?

Question.. i want to cut the curves that are outside a form just like the fonction trim in autocad? is there a simple way to trim or split or itnersect curves with other curves or curves with lines? i dont find a solution so far.. I did the Curve/Curve than the Shatter component and finaly the Cull Pattern Component to remove all the parts that I don't want but it's not working very good. I probably did it the wrong way. I went to many differents sites to figure it out but still don't get the result that I want.

Thanks

M.P

pannel.3dm

line.gh

Comment

You need to be a member of Grasshopper to add comments!

Comment by lintao on January 11, 2016 at 1:19am: i think you can use trim with region.

Comment by marianne pasqueli on December 25, 2015 at 8:52am: thanks :)

Comment by David Rutten on December 24, 2015 at 10:33am: You're better off posting a new discussion in the forum rather than a personal blog post if you have a question. Fewer people will see this here.